195mm Long Handle Flux Brush Compact Brush Head for Refrigeration Copper Tubing

Problem: No Access to Refrigeration Joints

Refrigeration and AC joints are often set deep inside a unit, boxed in by other pipes and components.

A standard brush cannot reach the socket, so flux is applied by feel and the joint quality becomes a gamble.

Cause: Short Reach and Bulky Heads

Most flux brushes are around 150mm or less, which leaves the hand fouling the casing.

Wide heads cannot slip between closely spaced tubing, so flux lands on the wrong surfaces or nowhere useful.

Solution: 195mm Reach with a Compact Head

The MT-FB195C pairs a 195mm natural wood handle with a compact head, so the bristles reach the joint while the hand stays outside the unit.

The narrow head slips between pipes and applies flux precisely on the socket, reducing contamination of nearby components.

An aluminium ferrule keeps the bristles secure under the awkward angles common in compressor bays.

Specifications

Selection Guide

Choose the 195mm reach where joints sit deep in casings or behind other pipe runs.

Match the compact head to small-bore copper and keep a standard head for open runs.

Where flux contamination is critical, prefer the narrow head to minimise overspill.

Application Scenarios

Refrigeration copper tubing, air conditioning installations and maintenance contractor repairs suit this brush.

It also helps on heat pump pipework where joints are crowded close to the outdoor unit.

Maintenance and Storage

After refrigeration work, flux left on the head can attract moisture. Rinse and dry the brush before it goes back in the van.

Store the long handle flat so it does not take a set, and protect the compact head from crushing under heavier tools.

Check the compact head for fraying each week; a tidy head is what lets it slip between crowded pipes.

Quality and Compliance Notes

Each long-handle brush is inspected for handle straightness, bristle retention and ferrule crimp strength before packing.

The aluminium ferrule is checked for corrosion resistance, and the compact head is verified for even density, under an ISO 9001:2015 system.

Packed in trays that hold the head clear of the carton wall, the brushes arrive with the compact geometry intact. That geometry is the whole point on refrigeration work, where a splayed head cannot reach the joint at all.

Because the compact head holds a small, measured charge, there is far less flux to clean off the surrounding components after each joint.

FAQ

Does the compact head hold enough flux?

Yes. For small-bore refrigeration joints, a compact head carries the right amount, which also limits overspill.

Is 195mm long enough for most units?

For typical domestic and light commercial units, 195mm clears the casing and reaches most joints comfortably.

Can I bend the handle to reach further?

No. The wooden handle should not be bent. Use the reach provided and reposition the unit or your stance instead.

Contact Morita to buy in bulk at factory pricing or request samples.